The service manual is as described and received the link to the download sooner than expected. Great service, quality product. This site is a big help in the electronics repair business.
I ordered this manual sometime in the afternoon and I received it on my e-mail the same evening.
This is a fantastically good and properly scanned copy of the original manual. All pages are of the same scale and they overlap each other. It means that you can print the manual and easily make it as a convenient paper manual.
The content of the manual is fantastic. Alignment descriptions, PCB layouts and elementary diagrams are explicit and precise. I immediately found what I was looking for. Thanks to this manual and Owner-Manuals.com my amplifier is alive again. Many thanx indded!
Text excerpt from page 85 (click to view)
15 July 1994
SCANNER SECTION
[C] [B]
[C] [B] [E]
[D] 3. Put the positioning pins in the front and rear holes [B] of the first scanner. Make sure that the positioning pin can be set in the holes smoothly. 4. If the pins did not fit smoothly, adjust the position of the first scanner with the screws [C]. 5. Check and adjust the position of the second scanner using the same procedure as in steps 3 and 4. 6. Slide the scanner unit and remove the sensor cover [D] (2 screws). 7. Connect the probes of the multimeter to the sensor�s connector. CN1: +5V CN2: GND CN3: Scanner H.P (Signal) 8. Slide the sensor bracket [E] and tighten the bracket when the sensor output goes to low (5 V to 0 V). 9. Check the optics adjustments and adjust them if necessary (see section 3).